Handheld - Casserole Dish - Handle and Foot
Handheld - Casserole Dish - Handle and Foot
Couldn't load pickup availability
These two dies extrude the handle and foot portions of the casserole die. The full casserole die is available for most of the wall-mounted extruders, such as this listing for the NorthStar extruder. Some potters wanted to use the wall mount to extrude only the wall section, and then extrude the handle and feet portions using a handheld extruder since you only need a short length.
These dies fit in 2" handheld extruders.
The original casserole design was made by Old Ash Artisans and is modified and reproduced here by permission. You can watch their YouTube video on how to use the die.
Materials
Materials
The die and cutter are 3D-printed using PLA filament. PLA is a plastic made from starch (not petrochemicals) and is compostable in industrial composters.
It is the same material used to make compostable eating utensils.
Care information
Care information
To clean, remove as much clay as possible. Let remaining clay dry completely. Soak in water and brush with soft-bristled brush. Not dishwasher safe.
Compatibility
Compatibility
LittleChip Tools is not affiliated with any extruder manufacturer. The dies are designed to be compatible with the extruders, but said compatibility is the responsibility of this store and not the extruder manufacturer. All trademarks and IP for the extruders and for the dies are the property of the respective companies.
